Topic 1

Stress and strain

Before you start

You need force in newtons, area in square metres, and the idea that a spring stretches more when you pull harder. Remember that 1 mm² = 10⁻⁶ m².

Hang the same load from a thin wire and from a thick one. The thin wire is far more likely to snap, even though the force is the same. What matters is the force shared over each bit of the cross-section.

A 314 N load on wires of different thickness

cross-sectionstress4 × 10⁸ Pa
diameter
1 mm
area = π d² / 4
0.79 mm²
stress = F / A
4 × 10⁸ Pa

With π = 3.14, the 1 mm wire carries 4 × 10⁸ Pa and the 2 mm wire 1 × 10⁸ Pa: twice the diameter, a quarter of the stress.

Predict first

A load hangs from a wire. The wire is swapped for one of the same material with twice the diameter, carrying the same load. What happens to the stress in the wire?

Stress is the restoring force per unit area of the cross-section. Its unit is N/m², called the pascal (Pa).

stress = F / A

F is the force, A the cross-section area

Strain measures how much the wire has stretched compared with its length. It is a ratio of two lengths, so it has no unit. A 2 m wire that stretches by 1 mm has a strain of 0.001 / 2 = 5 × 10⁻⁴.

strain = ΔL / L

ΔL is the increase in length, L the original length