Topic 3

Rectifiers: turning AC into DC

Mains supply is alternating: the voltage swings positive, then negative, 50 times a second in India. Electronic circuits need a voltage that stays one way. A rectifier uses diodes to get there.

Predict first

A 50 Hz AC supply feeds a full-wave rectifier. How many times per second does the output reach a peak?

Rectifying a 50 Hz supplyStep 1 / 4
inputhalf-wavefull-wave

The input is a 50 Hz alternating voltage. One full cycle takes 20 ms: positive for half of it, negative for the other half.

Text version
  1. The input is a 50 Hz alternating voltage. One full cycle takes 20 ms: positive for half of it, negative for the other half.
  2. A half-wave rectifier has one diode. It conducts only while the input is positive, so the negative halves are lost.
  3. A full-wave rectifier uses two diodes (or four in a bridge). The negative halves are turned around and come out positive too.
  4. Count the humps in 40 ms. Half-wave: 2, which is 50 per second. Full-wave: 4, which is 100 per second.

A half-wave rectifier has one diode. It passes only the positive halves, so its output pulses at the same frequency as the input. A full-wave rectifier uses two diodes with a centre-tapped transformer, or four in a bridge. It flips the negative halves, so the output pulses at twice the input frequency.

half-wave: f_out = f_in full-wave: f_out = 2 f_in

f: frequency of the output pulses

Smoothing

The output is one-way but still bumpy. A capacitor placed across the output fills up at each peak and feeds the load between peaks, which smooths it towards a steady DC.