Topic 3

Adding voltages in a series LCR circuit

Connect a resistor, an inductor and a capacitor in series across an AC source. The same current flows through all three, but the three voltages reach their peaks at different moments.

Predict first

In a series LCR circuit the rms voltages are 120 V across the resistor, 320 V across the inductor and 160 V across the capacitor. What is the rms voltage of the source?

Because the voltages are out of step you cannot simply add them. Draw each one as an arrow, called a phasor. VR points along the current, VL points 90° ahead of it and VC points 90° behind it. Then add the arrows.

Adding the voltages as arrowsStep 1 / 5
current IVR = 120 V

The same current, 4 A, flows through every part. VR = I R = 120 V is in step with it, so it points along the current.

Text version
  1. The same current, 4 A, flows through every part. VR = I R = 120 V is in step with it, so it points along the current.
  2. VL = I XL = 320 V leads the current by 90°, so it points straight up.
  3. VC = I XC = 160 V lags the current by 90°, so it points straight down.
  4. VL and VC point opposite ways and partly cancel: 320 − 160 = 160 V upwards.
  5. The supply voltage is the diagonal: √(120² + 160²) = 200 V. It leads the current by φ ≈ 53°, where tan φ = 160 / 120.

Z = √(R² + (XL − XC)²) tan φ = (XL − XC) / R

impedance Z, and the phase angle φ by which the voltage leads the current

Impedance Z plays the part of resistance for the whole circuit: Irms = Vrms / Z. In the diagram R = 30 Ω, XL = 80 Ω and XC = 40 Ω, so Z = √(30² + 40²) = 50 Ω and a 200 V supply drives 4 A.

Not a mistake

The voltage across the inductor alone, 320 V, is larger than the supply voltage of 200 V. That is allowed, because VL and VC are out of step and cancel in part at every instant.